Kitchenaid Electric Slide-In Range Convection Fan Assembly Replacement #W11093167

Print ContentSave Content

Skill Level

Total Parts Cost

$152.63

Estimated Savings

$112.50

04:04

Description

This video provides step-by-step instructions for replacing the convection fan assembly on a Kitchenaid electric slide-in range (model #KSEB900ESS2). The most common reason for replacing the assembly is if the convection setting on the oven is not working properly.

All of the information in this fan replacement video is applicable to the following brands: Maytag, Amana, Magic Chef, Whirlpool, Tappan, Estate, Kitchenaide

Step By Step Instructions

Print Instructions

KitchenAid Electric Slide-In Range - KSEB900ESS2

Electric Range Convection Fan Assembly Replacement

Tools needed: Phillips-head screwdriver

Shock

Be sure to unplug the power cord or shut off the power supply.

Fully open the oven door and rotate both door hinge locks back.

Heavy

Partially close the door, then lift and pull the door toward you to remove.

With the handle side down, set the door on a blanket.

Slide out the oven racks.

Note the orientation of the convection fan cover then use a Phillips-head screwdriver to unthread the screws to release the cover from the rear panel.

Next, unthread the three mounting screws to release the fan assembly.

Disconnect the two heater wires as well as the motor wire connecter and you can remove the old assembly.

Install the new convection fan assembly by first connecting the motor wire connecter and the heater wires.

Align the assembly on the rear panel and replace the three mounting screws.

Reposition the cover and secure it with the screws.

Slide the oven racks into place.

Reinstall the oven door by inserting the door hinges into the hinge slots at a forty-five degree angle.

Lower the door to its fully open position, then rotate the hinge locks forward.

Plug the power cord back in or restore the power supply and the electric range should be ready for use.