Amana Dryer Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer electric heating element assembly

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

Dryer idler pulley assembly. Includes bracket and attached pulley

The Dryer Maintenance Kit 4392067 includes drum support rollers, a multi-rib belt, an idler pulley wheel, triangle clips, and a washer for a complete maintenance overhaul. If your Whirlpool, Kenmore, or Maytag dryer is making loud noises or the drum is not turning, it may be time for replacement.

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Door handle, white. Snaps in place

The Whirlpool Dryer Cycling Thermostat WP3387134, rated at L155-25, regulates the temperature within your dryer. Signs that the thermostat needs replacement include inconsistent drying temperatures or the dryer running excessively hot. The WP3387134 is compatible with various dryer models.

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.