Price Match GuaranteeGE Dryer DPVH880GJ2MG Parts
Shop replacement repair parts for GE Dryer model DPVH880GJ2MG
Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Rear drum bearing sleeve
Light bulb, 120V, 10W
Idler pulley wheel, plastic
Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.
Door switch
Inlet control thermistor. Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.
Thermostat, high limit
O-Ring for retaining drum bearing sleeve on shaft
Screw #10
Dryer door catch kit
Drum support shaft and bearing assembly
Door strike
Flame sensor at side of burner tube
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic