Amana Dryer steam function not working

If your Amana dryer steam function is not working, the most likely cause is a failed control board or main control board that is not sending power to the water inlet or steam generator. Inspect the control board for burned or shorted components since the board cannot be easily bench-tested. If the board looks OK and power is reaching the steam system but no steam is produced, the steam generator itself may be defective and need replacement. Next check the basic plumbing: make sure the water supply hose is connected and the dryer is getting water. A clogged or damaged steam nozzle can block mist from entering the drum, and a bad water inlet valve will prevent water flow even when energized. Whether you see “dryer steam not working,” “steam fresh not working,” or “steam sanitize not working,” these are the most common causes in descending order of likelihood. Enter your model number on RepairClinic.com to find the exact replacement part that fits your dryer.

01 - Amana Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Enter model number to search for the required part specific to your product

Need help finding your model number?

Shop all Amana Dryer Control Board Parts

Common

02 - Amana Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Shop all Amana Dryer Main Control Board Parts

Common

03 - Amana Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.

Shop all Amana Dryer Steam Generator Parts

Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Common

05 - Amana Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.

Shop all Amana Dryer Nozzle Parts

Less Common

06 - Amana Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.

Shop all Amana Dryer Water Inlet Valve Parts

Less Common

07 - Water Supply Valves are Closed

The water supply valve needs to be turned on to supply water to the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Less Common