Choose Product
Identify Problem
03
Find Solutions
Air conditioner compressor won't run
Brand:Amana
Model:WES1093HES P6968412R
Product:Air Conditioner
Featured Video
Air Conditioner Compressor Won't Run? Air Conditioner Troubleshooting
03:58
Common solutions for: Air conditioner compressor won't run
01 - Temperature Control Thermostat
The temperature control thermostat has electrical contacts inside that burn out over time. It is possible for the thermostat to still turn on the fan motor but not the compressor motor.
Highly Likely
02 - Thermostat
The thermostat monitors the temperature of the air. When the air temperature rises above a set point, the thermostat activates a switch to provide power to the fan and compressor. If the thermostat is defective, it may prevent the compressor from running. If you determine that the compressor is at fault, replace it.
Highly Likely
03 - Overload
The overload protects the compressor from burning out if it draws too much current. Over time, the overload can burn out. To determine if the overload is burned out, use a multimeter to test the overload for continuity. If the overload does not have continuity, replace it.
Highly Likely
04 - Compressor
The compressor itself might be defective. However, this is not usually the case. Before replacing the compressor, be sure to check more commonly defective components—particularly the overload protector and the compressor capacitor. If the compressor is defective, it should only be replaced by a licensed technician.
Genuine Part
Highly Likely
05 - Capacitor
The capacitor is attached to the compressor by electrical leads. If the capacitor burns out, the compressor won’t run. To determine whether the capacitor is burned out, use a multimeter to test it for continuity. If the capacitor does not have continuity, replace it.
Less Common
06 - Incoming Power Problem
Check to see if there is power to the air conditioner. One or more indicator lights on the control board should be illuminated. If there is no power to the air conditioner, check to see if a circuit breaker has tripped or a fuse has blown. Confirm the unit is plugged in and has power.
Less Common