FAQ 2O DISH

Standing water in the tub usually means restricted drain flow or a pump/timer sequence issue. Use this checklist:

1. Cancel the cycle and remove power for 60 seconds, then retry a drain-only or short cycle.
2. Inspect the sink air gap and disposal knockout plug if the drain routes through a disposal.
3. Check the high loop on the drain hose; it should rise before entering the cabinet.

• Filter / sump area
  • Remove the lower rack and clean the fine filter screen.
  • Look for glass or seeds blocking the impeller.
• Drain hose
  • Verify no kinks behind the unit.
  • Confirm the hose is not siphoning (high loop).

Note: This block is sample content for import testing only; validate against your model before publishing.

Regular care reduces odors and pump strain:

• Monthly
  • Clean the door gasket with a soft cloth; leave the door cracked after cycles.
  • Run a hot vinegar or citric-acid cleaner cycle per manufacturer guidance.
• Quarterly
  1. Remove and rinse spray arms; clear jet holes with a nylon pick.
  2. Verify rinse-aid level and detergent dispenser operation.