Shop replacement repair parts for Goodman Packaged Unit/RTU model GPG13360901AC

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Beckett burner

Gas valve, 24v 3.5" wc

Contactor, 2 pole, 30 amp, 24 vac **Special Note** This may replace single pole contactor and require a technican to install (based on model #)

Run cap 35/5mfd/440v/dual round

Screw, #10 X 1/2, black,

.43 Natural gas burner orifice

300f m/r rollout limit switch

Nut, acorn 5/16 hex black

Blower motor 208-230v1ph 830rpm 1sp

Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure switch hose 3/16" I.D.

Pressure switch,(-)0.33pr

Ignition control board. The ignition control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.