LG Washer Cold Water Inlet Valve Replacement 5221ER1003S

Total Parts Cost

$NaN

05:05

Description

This video provides step-by-step repair instructions for replacing the cold water inlet valve in an LG washer (Model WM4000HBA). The most common reason for replacing this part is if it's missing or broken.

This replacement video is applicable to the following brands:
LG

Don't forget to like and comment on this video and subscribe to our channel!

Step By Step Instructions

Print Instructions

To replace the cold water inlet valve in your lg washer, you will need channellock pliers, a flathead screwdriver, pliers, and a drill driver with a phillips bit.

Before you begin the procedure, unplug the washer.

Turn off the water supply.

Pull the washer away from the wall.

Unthread the water supply lines. be prepared for water to spill.

Unthread the two screws on the top panel.

Slide and lift the top panel off.

Remove the twist tie.

Slide the three tension clamps back on the hose.

Note the orientation of the hoses and use the flathead to detach them from the inlet valve.

Note the orientation of the plugs and unplug the cold water inlet valve.

Unthread the screw on the inlet valve bracket.

Slide the bracket to remove it.

Then wiggle the valve free from the bracket.

To install the cold water inlet valve, press the new valve in the bracket.

Insert the bracket in the panel and slide to lock in place.

Rethread the screw to secure the bracket.

Plug in the inlet valve.

Attach the hoses to the inlet valve.

Slide the tension clamps into place.

Fasten the hoses together with the twist tie.

Set and slide the top panel onto the washer.

Rethread the two screws onto the panel.

Push the washer back into place.

Turn on the water supply, as well as the power, and your washer should be ready for use.