Frigidaire Induction Range Door Switch Replacement 316445500

Total Parts Cost

$NaN

03:43

Description

This video provides step-by-step repair instructions for replacing the door switch on a Frigidaire induction range. The most common reason for replacing this part is if it is damaged.

All of the information for this part replacement video is applicable to the following brands:
Frigidaire

Step By Step Instructions

Print Instructions

Frigidaire Induction Range - GCRI3058AFD

Frigidaire Induction Range Door Switch Replacement

Tools needed: Phillips-head screwdriver, flat-head screwdriver

Shock

Before you begin the procedure, unplug the power cord or shut off the power supply.

Open the oven door and use the Phillips-head screwdriver to unthread the three screws securing the main top.

Heavy

With the screws unthreaded, pull the main top forward to fully remove.

Next. Unthread the three screws securing the induction coil support panel.

Sharp

Lift the panel up and support it.

Disconnect the wires from the oven door switch.

You can use a flat-head screwdriver to depress the tabs to release the old switch from the front panel.

To install the new oven door switch, snap it into place in the front panel, then connect the wires to the terminals.

Remove the support and reposition the induction coil support panel.

Thread the three mounting screws to secure.

Reinstall the main top by aligning the sides under the front support bracket, then carefully slide the top back, pressing the induction coils down as you do this.

With the top in place, thread the three screws in front to fully secure it.

Plug the power cord back in or restore the power supply and the induction range should be ready for use.