Briggs & Stratton Small Engine Carburetor Gasket Replacement #791718

Total Parts Cost

$NaN

03:15

Description

This video provides step-by-step instructions for replacing the carburetor gasket on Briggs & Stratton small engines. The most common reason for replacing this part is if it is damaged or missing.

All of the information in this video is applicable to the following brands: Briggs & Stratton

Step By Step Instructions

Print Instructions

To replace the carburetor gasket on this briggs and stratton engine…

… you will need a 5/16th inch nut driver and a t-30 torx bit.

Before you begin this procedure, make sure the engine has cooled.

Use the 5/16th inch nut driver to unthread the two mounting screws securing the air filter cover.

Remove the cover and the air filter…

…then unthread the screws securing the filter base.

Pull the choke lever off so you can move the base out of the way.

Using the t-30 torx bit, unthread the two mounting screws securing the carburetor, spacer, and gaskets.

If still intact, remove the old gasket.

Before you install the new carburetor gasket...

… confirm the second gasket and spacer are in place on the cylinder head…

… then reinsert the two mounting screws through the carburetor and slide the new gasket onto the screws.

Position the carburetor and thread the screws into the cylinder head.

Insert the two mounting screws through the air filter base…

… then align the base and thread the screws into the carburetor.

Replace the choke lever.

With the pre- cleaner positioned in the cover followed by the air filter with its rubber gasket facing outward…

… align the cover on the base…

… and secure it with the screws.

The engine should now be ready for use.