Whirlpool Matrix Refrigerator Rear Roller Replacement WPW10475495

Print ContentSave Content

Skill Level

Total Parts Cost

$27.05

Estimated Savings

$112.50

05:14

Description

This video provides step-by-step repair instructions for replacing the rear roller on a Whirlpool Matrix refrigerator (Model WRT318FMDB02). The most common reason for replacing this part is if it is damaged or missing.

All of the information for this video is applicable to the following brands:
Whirlpool, Maytag, Amana, Kitchenaid, Kenmore

Step By Step Instructions

Print Instructions

Whirlpool Matrix Refrigerator - WRT318FMDB02

Refrigerator Rear Roller Replacement

Tools needed: quarter-inch socket or nut driver, flat-head screwdriver

Shock

Be sure to unplug the power cord.

To move the refrigerator away from the wall, raise both front leveling legs.

Use a quarter-inch socket or nut driver to unthread all of the screws to release the lower rear access panel.

Heavy

To replace the right roller, lift up the right side of the appliance and support it.

Sharp

Use a flat-head screwdriver to help detach the retaining clip securing the roller axle.

Pull out the axle to release the old roller.

Install the new rear roller by aligning it in the frame then insert the axle to hold it in place.

Snap on the retaining clip.

Remove the support and lower the appliance.

To replace the left side roller, first unthread the screws securing the condenser fan motor mounting bracket.

Pull the bracket forward and tilt it to the left to remove.

Next, unthread the screw securing the drain pan to the base.

Unthread the screws to release the water inlet valve bracket from the frame.

You can disconnect the inlet valve wire connecter for better access.

Depress the drain pan tabs to release the pan from the base.

Now lift and support the appliance.

You can now replace the left side roller in the same manner as the right side roller.

With the new roller installed, remove the support and lower the appliance.

Snap the drain pan into place.

Connect the water inlet valve wire connecter, if applicable.

Reposition the inlet valve bracket and secure it to the frame with the screws.

Rethread the screw to secure the drain pan to the base.

Reposition the condenser fan motor mounting bracket.

Thread the screws.

Reinstall the access panel.

Push the refrigerator back against the wall and lower the front leveling legs.

Plug the power cord back in and your refrigerator should be ready for use.