Whirlpool/Kenmore Washer Water Inlet Spout #3360977

Print ContentSave Content

Skill Level

Total Parts Cost

$58.64

Estimated Savings

$112.50

02:53

Description

This video provides step-by-step instructions for replacing the water inlet spout on top loading direct drive Whirlpool washing machines. The most common reason for replacing the water inlet spout is when the washer is slow to fill and the spout is visibly damaged.

All the information in this inlet spout replacement video is applicable to the following brands: Whirlpool, Kenmore, KitchenAid, Roper, Maytag, Estate, Inglis, Crosley, Amana, Admiral

Tools used: flat-head screwdriver, Phillips head screwdriver, pliers, putty knife

Step By Step Instructions

Print Instructions

As with any repair, be sure you've unplugged the appliance before beginning.

Your first step is to move the control panel out of the way.

To do this, remove the screws found at either end.

On some models, these screws may be located in the rear panel or they may be covered by plastic end caps.

Pull the end cap off from the top to access the screw.

Remove both screws and rotate the panel up.

Some models use clips instead of screws to secure the control panel.

Insert a putty knife between the control panel and the cabinet to release the clips.

Unplug the wire connector and snap out the spring clips.

Using a flathead screwdriver, tilt the cabinet towards you, slide forward, and remove.

You're now ready to replace the water inlet spout.

Use pliers to release the clamp that secures the hose to the spout and pull the hose off.

Push the two tabs of the old spout outwards and lift up to detach the spout from the rear panel.

Install the new water inlet spout by inserting the top portion of the tabs into the rear panel.

Then push the bottom portion of the tabs outward and press down to lock the spout into place.

Reattach the hose and secure it with the clamp.

Now reinstall the cabinet.

The front edge of the cabinet slides underneath the base frame.

Use your foot to push it into position.

Align the two notches in each side of the cabinet with the tabs on each side of the base frame.

Now ease the cabinet to match up with the rear channel.

Reinstall the spring clips, reattach the wire connector, rotate the control panel down, and lock the clips into place or reinstall the two screws if applicable to your model.

Replace the end caps by aligning the tab with the slot at the bottom and snapping the cap into position.

You're now ready to plug the appliance back in to make sure it's functioning properly.